Comtech-ef-data CiLink Manual do Utilizador descarregar pdf (Página 31)

CSAT-5060/XSAT-7080 Transceiver iPAQ Link Revision 2

Operations MN/CiLink.IOM

3–9

3.3.2.5 Main Menu Æ Configuration Æ Redundancy Controller

• Force Online Unit # ▼ – This allows the user to observe or select which transceiver

in a redundancy configuration is currently online.

To switch between units, tap the trigger to display the options

(

XCVR1 or XCVR2), then highlight the desired transceiver.

Select

[Set Data] to update the configuration and bring the

selected unit online.

IMPORTANT

The Online Unit, as idenitifed on this screen,

should not be confused with the ‘Currently

Selected XCVR’ option available on several other

screens. The menu on this page is the only one

where the user has the capability to ‘force’ a

transceiver to be the Online Unit.

• Operating Mode

[Auto/Manual]▼ – This allows the user to

control the operating mode of the RSU-5060 (RED Box).

When in

Auto mode, the RED box monitors the state of

XCVR1 and XCVR2. If the online unit fails, the RED box will

automatically command both the TX and RX transfer switches to

change position.

IMPORTANT

If the offline unit is also faulted, no switchover will occur. Manual mode will not

monitor fault status for automatic switchover. To change operating modes, tap

the trigger (▼) to display the two options, highlight the desired mode, then

select

[Set Data].

• TXWG Switch [OK/FT] status only – Reports the fault status of the TX waveguide switch.

• RXWG Switch Status [OK/FT] status only – Reports the fault status of the RX waveguide

switch.

• 5V / 12V Controller Voltages status only – Displays the RED box internal power supply

voltages.

Tap

[Set Data] to save the updated configuration selections. Otherwise, tap [ok] to return to the

Main Menu from the Configuration Æ Redundancy Controller screen without saving any

changes.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38

Sem comentários

Comtech-ef-data CiLink Manual do Utilizador Página 31