Comtech-ef-data SDM-2020 Manual do Utilizador descarregar pdf (Página 161)

SDM-2020 Satellite Demodulator Revision 4

ECL/HSSI Data Interface MN/SDM2020D.IOM

10–9

10.1.4.3 Terrestrial Extended Signal Definitions

The HSSI specification has no provision for SYNC or DVALID signals. If terrestrial data

framing is desired, a sync byte (47 hex) is embedded into the data stream every 188 or

204 bytes, as selected in the modulator configuration. The modulator detects the sync

byte and formats the serial interface into a standard, error-protected 204 byte packet.

In order to support TM1449, PSYNC and DVALID will be routed to RESERVED (from

DCE) HSSI pins. Refer to Table 10-5 for definition of signals.

Table 10-5. Definition of Signals

Signal Definition

Transmitter Synchronization Signal

(TX PSYNC)

Indicates the beginning of a transport packet by signaling the

SYNC byte. Active per defined format timing.

Transmitter Data Valid (TX DVALID) Indicates valid data at the interface. Active per defined format

timing.

Carrier Detect (CD) Indicates Demodulator carrier tracking loop locked. Status

output. TTL output. Active High (programmable).

Demodulator Fault (DF) Open collector TTL signal indicating Demodulator Fault. Active

High. External pull-up required.

Modulator Fault (MF) Open collector TTL signal indicating Modulator Fault. Active

High. External pull-up required.

Receiver Synchronization (RX PSYNC) Indicates the beginning of a transport packet by signaling the

SYNC byte. Active per defined format timing.

Receiver Data Valid (RX DVALID) Indicates valid data at the interface. Active per defined format

timing.

10.1.4.4 Terrestrial Data Rate

The terrestrial interface supports synchronous data transfer rates from 1.5 to 70 Mbps.

Notes:

1. EIA-612 (Electrical Characteristics for an Interface at Data Signaling Rates

up to 52 Mbps) defines the electrical characteristics required for data

transfers up to 52 Mbps utilizing ECL driver/receiver technology.

2. The HSSI port will comply with EIA-612 for transfers less than 52 Mbps.

3. For short distances, an SCSI-2 cable will work, although the impedance will be

wrong.

The recommended cable is a CISCO “CAB-HSI1 (DTE to DCE)” or “CAB-HNUL

(DCE to DCE)” incorporating twisted, shielded pairs. The maximum cable length should

be ≤ 3 ft (7.62 cm) for the 70 Mbps transfer rates.

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 233 234

Sem comentários

Comtech-ef-data SDM-2020 Manual do Utilizador Página 161