Comtech EF Data CDM-710G Especificações descarregar pdf (Página 174)

CDM-710 Broadcast Satellite Modem Revision 11

Appendix A MN/CDM710.IOM

A–4

A.5.3 Address Delimiter

This is the “forward slash” character '/' (ASCII code 47).

A.5.4 Instruction Code

This is a three-character alphabetic sequence, which identifies the subject of the message. Wherever possible, the instruction codes have been

chosen to have some significance – e.g., TFQ for transmit frequency, RMD for receive modulation type, etc. This aids in the readability of

the message, should it be displayed in its raw ASCII form. Only upper case alphabetic characters may be used (A-Z, ASCII codes 65 - 90).

A.5.5 Instruction Code Qualifier

This is a single character, which further qualifies the preceding instruction code. Code Qualifiers obey the following rules:

1. From Controller-to-Target, the only permitted values are:

Symbol Definition

(ASCII code 61)

The ‘=’ code is used as the Assignment Operator (AO) and is used to indicate that the parameter defined by the preceding

byte should be set to the value of the argument (s) which follow it.

Example: in a message from Controller-to-Target, TFQ=0070.0000 would mean “set the transmit frequency to 70 MHz.”

(ASCII code 63)

The ‘?’ code is used as the Query Operator (QO) and is used to indicate that the Target should return the current value of

the parameters defined by the preceding byte.

Example: in a message from Controller-to-Target, TFQ? Would mean “return the current value of the transmit frequency.”

2. From Target-to-Controller, the only permitted values are:

Symbol Definition

(ASCII code 61)

The ‘=’ code is used in two ways:

First, if the Controller has sent a query code to a Target

Example: TFQ? (meaning ‘what’s the Transmit frequency?’), the Target would respond with TFQ=xxxx.xxxx, where

xxxx.xxxx represents the frequency in question.

Second,If the Controller sends an instruction to set a parameter to a particular value, then, providing the value sent is

valid, the Target will acknowledge the message by replying with TFQ=(with no message arguments)

(ASCII code 63)

If the Controller sends an instruction to set a parameter to a particular value, then, if the value sent is not valid, the Target

will acknowledge the message by replying (for example) with TFQ? (with no message arguments). This indicates that there

was an error in the message sent by the Controller.

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 237 238

Sem comentários

Modelos	Tipo de documento
395941	Manual de usuario Energy Sistem 395941 16GB Black smartphone, 2 paginas
397259	Manual de usuario Energy Sistem 397259 8GB White smartphone, 2 paginas
421787	Manual de usuario Energy Sistem 421787 4GB Multi smartphone, 2 paginas
Energy Phone Max	Manual de usuario Energy Sistem Energy Phone Max 8GB Black, Red, Yellow, 2 paginas
Energy Phone Pro Qi	Manual de usuario Energy Sistem Energy Phone Pro Qi 32GB Silver, 2 paginas

Comtech EF Data CDM-710G Especificações Página 174