Comtech EF Data Vipersat CDD-564L Especificações descarregar pdf (Página 56)

CDD-562L/564 Demodulator with IP Module Revision 2

Rear Panel Connections MN/CDD564L.IOM

3–10

3.3.3.2 DC Operation – Replacing Fuses

The CDD-56X uses two 5mm x 20mm Slow-blow fuses – one each for line and neutral

connections. The fuses are contained within a fuse holder that is press-fit into the body of the DC

power module (located on the rear panel, Figure 3-8).



Feature Description

1 Hinged Flap

2 Press-fit Fuse Holder

3 Fuse (2X)



Figure 3-8. Replacing CDD-56X DC Fuses

To replace the fuse(s):

DISCONNECT THE POWER SUPPLY BEFORE PROCEEDING!

• First, using a flat-bladed screwdriver, use the slot to pry open and swing back the

hinged flap.

• Next, extract the press-fit fuse holder:

o Using the screwdriver, disengage the fuse holder outward from the DC power module.

o Using your fingers, pull the holder straight out of the module.

• Then, remove and replace the T8A (8 Amp) fuses as needed.



FORCONTINUEDOPERATORSAFETY,ALWAYSREPLACETHEFUSESWITHTHE

CORRECTTYPEANDRATING.

• Finally, re-seat the fuse holder into the DC power module, and close the protective flap.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 253 254

Sem comentários

Comtech EF Data Vipersat CDD-564L Especificações Página 56