Comtech-ef-data RCF6001 Manual do Utilizador descarregar pdf (Página 69)

RCF6001 Satellite Terminal ODU Installation

TM082 - Rev. 1.0 Page 5-23

Mounting the Typical C-Band High Power Outdoor Unit Assembly

The following diagram and instructions pertain to mounting a 10-Watt, 20-Watt, 40-Watt or

60-Watt ODU (BUC) to an antenna using a Radyne ComStream supplied mounting plate and

hardware kits.

The Outdoor Unit is pre-assembled as shown in Figure 4-3. The User antenna type and design

determine the mounting location of this assembly. Refer to Table 4-4 for the mounting kit parts

list. The flexible waveguide is not provided with the mounting kit.

Table 4-9Offset Mounting Kit (3120-0002)

Item Part # Description Qty

16267P2

Gasket 2

2 2400-3038-1008 SCRPNHD 10-32x5/8 LG 16

3 2400-3044-138 Washer, Medlock NO. 10 16

4 36015 U-Bolt 2

5 2400-3044-141 Washer, Medlock 3/8 4

6 2400-3045-814 Washer, FL 3/8 OD. 81 4

7 2400-3047-010 Nut, Plain Hex 3/8-16 4

Step 50. Important: Make sure that the Gasket is installed and that the waveguide flange is properly

sealed to prevent moisture from entering the waveguide.

Step 7. First secure the bottom section of the ODU mounting assembly by

placing the ODU (BUC) mounting assembly onto the diagonal support

member and secure using (1) U-Bolt and noted hardware.

Step 8. Secure the top section of the ODU (BUC) mounting assembly

onto the cross member (support pole/pipe) and secure using (1) U-Bolt and

noted hardware.

Step 9. If applicable, attach flexible waveguide between the ODU (BUC)

and feed assembly using the hardware noted.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 77 78

Sem comentários

Comtech-ef-data RCF6001 Manual do Utilizador Página 69