Comtech-ef-data Vipersat Circuit Scheduler v3.7.x ArrangeLink Manual do Utilizador descarregar pdf (Página 61)

Chapter 3 - Using ArrangeLink 3-19

Schedule Setup

Figure 3-19

Point-to-Point InBand Circuit, Point Two

When configuration of the Circuit Specific Options is completed, click on the

Continue button to proceed to the Advanced Switching tab.

Point-to-MultiPoint Out-of-Band

Although this Circuit Type appears as a selection, it is not supported in v3.7.2 of

the VMS.

Point-to-MultiPoint InBand

In figure 3-20, the Point-to-Multipoint InBand circuit type has been selected

using the Circuit Type radio button. Use the following procedure to select the

equipment to be used for this circuit during the scheduled event.

1. Select the Remote site to be used as the transmitter for the scheduled event

from the network tree view, as shown in the figure.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 87 88

Sem comentários

Comtech-ef-data Vipersat Circuit Scheduler v3.7.x ArrangeLink Manual do Utilizador Página 61