
User Interfaces DD2401 Satellite Demodulator
4-10 MN-DD2401 - Rev. G
In acknowledgment (response) packets, the operational code <OPCODE> field of the message
packet is set to 0 by the receiving devices when the message intended for the device is evaluated
as valid. The device that receives the valid message then exchanges the <SOURCE ID> with the
<DESTINATION ID>, sets the <OPCODE> to zero in order to indicate that a good message was
received, and returns the packet to the originator. This “GOOD MESSAGE” opcode is one of nine
global responses. Global response opcodes are common responses, issued to the M&C
computer or to another device, that can originate from and are interpreted by all Radyne
equipment in the same manner. These are summarized as follows (all opcode values are
expressed in decimal form):
Table 4-5. Response Opcodes
Response Opcode Description
Command Not Allowed in LOCAL Mode
Command Not Allowed in AUTO Mode
Unable to Process Command
The following response error codes are specific to the DD2401/DD2401L:
Response Opcode Description
DPARM_SWEEPBOUNDARY_ERROR
DPARM_DEMODULATIONTYPE_ERROR
DPARM_DIFFERENTIALDECODER_ERROR
DPARM_DESCRAMBLERCONTROL_ERROR
DPARM_DESCRAMBLERTYPE_ERROR
DPARM_BUFFERCLOCKPOL_ERROR
DPARM_OPERATINGMODE_ERROR
DPARM_BERMEASUREPERIOD_ERROR
DPARM_INTERFACETYPE_ERROR
DPARM_NOTIMPLEMENTED_ERROR
DPARM_EXTERNALEXCSOURCE_ERROR
DPARM_BUFFERSIZEMSEC_ERROR
DPARM_BUFFERSIZEBYTES_ERROR
Comentários a estes Manuais