Comtech EF Data LPOD Especificações descarregar pdf (Página 24)

LPODnet M&C Netbook Accessory Revision 3

Setup MN-LPODNET

2–4

2.2.1 CA-0000352 RJ-45 Connectors

2.2.1.1 (1X) RJ-45 Connection for Standalone Applications

For standalone applications, the CA-0000352 Ethernet Interface Cable connects

directly between the SSPA and the LPODnet.

Figure 2-5. CA-0000352 RJ-45 Standalone Application Direct Connection

or standalone applications only – Follow these steps to directly connect the Ethernet Interface

Cable RJ-45 ‘J3’ connector to the LPODnet (Figure 2-5):

Step

Task

Press down the tab on the CA-000352 cable ‘J3’ RJ-45 plug, and then insert the plug into the LPODnet’s

RJ-45 Ethernet network jack.

Be sure to tie back (or otherwise segregate from inadvertent use) the

CA-0000352 RJ-45 connector labeled J2-UNIT 1 REDSYS ONLY.

The connection is complete when the tab ‘clicks’ into position inside the LPODnet ’s RJ-45 Ethernet

network jack.

2.2.1.2 (3X) RJ-45 Connections for 1:1 Redundancy Applications

Before proceeding further, you

should first read the detailed information provided

in Appendix A. 1:1 REDUNDANCY in either the LPOD Outdoor Amplifier / Block Up

Converter (BUC) Installation and Operation Manual (CEFD P/N MN-LPOD) or the

SPOD Outdoor Amplifier Installation and Operation Manual (CEFD P/N

MN-SPODPSX).

Typical for any 1:1 Redundancy configuration, the ‘J2’ and ‘J3’ RJ-45 connectors are both

plugged into a user-provided Ethernet switch or hub. A user-provided Ethernet cable is then

connected from the Ethernet switch or hub to the LPODnet ’s RJ-45 Ethernet network jack.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 59 60

Sem comentários

Comtech EF Data LPOD Especificações Página 24