Comtech-ef-data NetVue Release 1.1 User Guide Manual do Utilizador Página 241

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 265
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 240
SNMP Managers Revision 3
NetVue User Guide MN-NETVUE
A–4
<Name>MyName</Name>
<IP port="361">201.120.212.0</IP>
...
</SnmpManager>
...
</SnmpManagers>
IMPORTANT
The SLSNMPAgent process listens for Get and Set messages using the same port as
the Windows SNMP service, by default.
If both must run at the same time, change the port for either the SLSNMPAgent or the
Windows SNMP service.
A.3 Configuring the SNMP manager
A.3.1 In System Display
1. Go to the top menu and choose Advanced SNMP Managers.
2. In the title bar of the
SNMP Managers section, click New.
3. On the first page of the
New SNMP Manager Wizard, click Next.
4. On the second page, specify these properties, then click
Next.
Name
The name of the SNMP manager (HP OpenView, IBM Tivoli Netcool, etc.).
IP Address
The IP address of the SNMP manager; i.e., the address to which the SNMP traps are sent.
Community String
The community string to be used in all SNMP traps toward the SNMP manager you are configuring.
SNMP Version
The SNMP version: SNMPv1, or the default SNMPv2.
5. To cause the trap receiver to acknowledge every SNMP packet sent by NetVue, select
Inform messages.
Then, specify two settings:
Resend
After sending an Inform message, NetVue waits for an acknowledgement for this period of time.
Vista de página 240
1 2 ... 236 237 238 239 240 241 242 243 244 245 246 ... 264 265

Comentários a estes Manuais

Sem comentários